Over-Engineered Performance Products for Severe-Service Assets
Barracuda Performance Products helps industrial teams extend asset life, reduce avoidable maintenance, and improve lifecycle value across oil & gas, concrete construction, and industrial marine environments.
Our products are built for the conditions that punish assets most: corrosion, abrasion, chemical exposure, UV, weathering, emissions pathways, and repeated service cycles.
Same workflows. Better outcomes. Lower cost to own.
Contact Us to Learn More
Most industrial failures aren’t surprises. They happen in the same places, under the same conditions, on the same maintenance schedule, and most of the industry keeps selling the same products into those same failure points.
Barracuda takes a different approach. We engineer around known failure modes, and we’re precise about how we do it. Select BPP products incorporate Pristine Graphene™ (PG), where its material properties can measurably improve durability, barrier performance, wear resistance, or service life. You don’t have to keep relying on the same materials that give you early failures again and again.
The goal is always the same: help the asset last longer, fail less often, and cost less to own.
Advanced EFR drain hose systems engineered for chemical resistance, abrasion protection, and long service life. Dsigned to reduce maintenance touchpoints and keep drainage performance predictable across inspection cycles. ​
Learn More
Emissions-mitigation covers for the exposed EFR tank leg section above the roof. They are designed to reduce vapor release at a known pathway while delivering long service life through UV-resistant, high tear-strength construction (warranty-backed).​
Learn More
UHMWPE tank leg feet designed to reduce emissions by addressing the open-leg pathway, and protect the tank bottom when legs land (especially when legs miss striker plates). Built for in-service retrofit or new construction. ​
Learn More
Coating systems built to fight MIC/anti-fungal drivers, corrosion, abrasion, and chemical exposure. They support longer intervals between recoats and more predictable maintenance planning. ​
Learn More
Pristine Graphene admixtures are designed to improve strength and early strength, enhance workability, and support faster finishing. This helps reduce total mix cost by optimizing performance and reducing reliance on other admixtures. ​
Learn More
Short-run flexible pipe packages for refineries and chemical plants—ideal for tie-ins, reroutes, bypasses, and rehabilitation scopes where you want fewer connections, faster installs, and corrosion-resistant performance. Optimized for <1,000’ runs, with longer packaged lengths available when needed.​
Learn MoreThe story is performance, not PG. BPP uses PG selectively, where its material properties can measurably improve durability, barrier performance, wear resistance, friction reduction, or matrix strength in ways that matter in the field.
PG is used in select tank, coating, seal, and material systems where heat, chemicals, abrasion, UV exposure, and repeated service cycles accelerate degradation.
The result is longer-lasting performance that stays aligned with inspection realities, maintenance planning, and field installation requirements.
PG is used in select coating systems where corrosion, abrasion, weathering, microbial/fungal exposure, and chemical attack drive early failure.
By improving barrier performance and reinforcing the coating matrix, PG can help coatings hold performance longer and support more predictable maintenance intervals.
PG is incorporated into select concrete admixture systems to improve workability, strength development, durability, permeability performance, and long-term surface reliability.
It is designed to improve concrete performance without changing how crews place, finish, or maintain the concrete.
Barracuda products are designed to fit the realities of industrial work: existing assets, established specs, inspection cycles, maintenance windows, contractor familiarity, and procurement review.
We are giving you practical upgrades that fit existing specs, survive procurement review, and perform in the conditions your assets actually operate in.
The best place to begin is not with a product. It is with the failure point you are tired of repairing. Tell us where the asset is wearing out, leaking, corroding, cracking, abrading, or creating repeat maintenance. We will help determine whether a BPP product is the right fit for your specific needs.
Start with a conversation. Move forward only when the application makes sense.